Home

How To Make Your Wood Deck Look Brand New Again

deck building tips, if you aren’t privy to the best hints for making your wood deck look brand new again, then you need to read on . We’re going to discuss the most common forms of wood deck damage and how to reduce or even eliminate those problems with just a few simple steps. The good news is that many decks are crafted from wood that features natural resistance to many of the hazards that can negatively affect these materials. The most popular woods like redwood and cedar or pressure-treated pine can stand up to dangers like insects and termites, but moisture and heavy UV radiation can be quite damaging. So here are some of the things you can do to help restore your wood’s natural beauty:

Cleaning

The first thing to do is clear away all the debris that has settled in. Branches, twigs, leaves, even dust and grime can all become layered on top of your wood. Brush it all away or get a leaf blower and clear it out. The next thing to do is start cleaning. You want a deck cleaner that can eradicate more than just mildew and other types of growth. You want something that has sodium percarbonate which is ideal at tackling the ugly oxidation that can turn your lush wood into a gray drab mess. Scrub thoroughly and rinse often with clean fresh water. In most cases, giving the deck a good cleaning with your preferred cleanser is going to do the trick nicely. Allow it to dry completely.

Rot Inspection

Again, this depends on the type of wood that was used to build your deck. A pressure-treated wood has already been reinforced against the effects of rot in much the same way it’s become resistant to termites. It’s those natural woods that have gone untreated that pose a greater risk for evidence of rot. If your home is in an area where there is higher than average precipitation or humidity, that excess moisture can promote rot in just about any type of wood. So this step is very important. You must closely inspect the deck for any evidence of rot. Check each and every board carefully, taking special care to investigate those hard to reach areas and locations that aren’t immediately visible to the eye. In other words, go searching for rot in those dark, damp places, usually located underneath the deck along the ledger, where the deck is connected to the house. Finding rot gives you two options, which you choose depends on how bad the wood has rotted.

Anything that’s about a ½ inch deep or less, you can probably salvage and repair without having to replace. Those rotten spots that have penetrated much deeper will likely need to be replaced. Replacement is extremely critical because the worse the rot gets, the weaker the wood becomes and your deck could start to become structurally unsound. Be sure you replace the rotten wood with new wood that is treated to be resistant to the impacts of rot. It’s the same thing with fence sealing fort worth, you want to treat the wood to protect it from moisture.

Stains or Discolored Spots

As you make your inspection for rot, you’re probably going to come across some stains or discolorations in the surface of your wood. This is due to UV rays or algae and mold or mildew. Regardless of the reason for the problem, the answer is going to be simple – bleach. However, you may need non-chlorinated versus chlorinated and that will depend on the type of wood you’re trying to restore. Most wood is better-suited for the former, while redwood and cedar can withstand a cleaner with chlorine bleach. This will be ideal for wiping out mold and mildew and it will bleach the wood surface to give it a bright new luster. Just be careful about which wood you’re cleaning with chlorinated bleach, as you could end up damaging the surface instead of restoring it.

 

YouTube
Pinterest
LinkedIn
Share