Roofing Materials

A Comprehensive Guide for Building a Fail-Proof Roof Top


A rooftop acts as the spine of the building. The roof is unarguably one of the most primary parts of the house that protects the house as well as its occupants from all the extraneous challenges including rough wind, rain, heat, storm, and snow. Besides its primary role of providing shelter, a roof also plays a crucial role in defining the overall look and style of the home.

Despite knowing the importance of a rooftop, unfortunately, the most neglected area of the home where a single crack in the sealing can sweep away the dreams of a perfect home. Even if you don’t know much about the highlighting reasons that result in a fail-proof top, just take a chimp ill as we are here to take you across several reasons like poor-maintenance and inexperienced workmanship that tends to the damage of the roof.

Put Quality of Roof over Other Factors

Most of the people emphasize on the internal beauty of the home while others pay attention to the gardens and unique architectural design but only a few recognize the significance of a quality roof and experienced contractors. Many wells experienced homemakers realize that installing the right roof flashing material properly at the initial stage don’t only save your time, energy and money but also protect home damage as well. Otherwise, the leakage from the joints of the roof can seep into the walls deteriorating building materials and causing moisture to the sensitive areas. So whether you are building a new house or retrofitting an existing one pay more attention to choosing the roof type and roof flashing system to avoid the headache later.

Leveling the Decks & Poor Ventilation

Subsequently, after knowing the roof flashing importance, it’s also very important to make sure whether the surface of the roof is in proper shape, properly protected with moisture barrier solutions and leveled equally or not. Secondly, in case of poor attic ventilation don’t forget to install polyethylene foam insulation to maintain the attic temperature and increase the shingle life span.

Choosing the Right Material

Since a roof flashing secures the roof joints from any possible water penetration or leakage into the house it’s very important to choose the right flashing material for the roof areas like chimneys, valleys, skylights, and dormers etc. Selecting the flashing type depends on the two factors, financial budget, and style. Here are a few most commonly used materials for your guidance;

Lead- used in smaller areas that are hard to maintain, known for its extreme durability.

Plastic- it can act as a strong, durable and waterproof shield option, but can’t be used with asphalt.    

Rubber- cheapest among all to install but not compatible with metal flashing.

Metal/Steel- the most common and durable flashing option, used for its robust, rust-proof, low maintenance and long-lasting properties.

Improper Flashing Installation:

In addition to flashing material, make sure your roofing contractor installs the flashing properly in the first go. Remind them to avoid any misalignment, overlapping, patchwork, improper nail placement, mismatched slate coloring or any other blunder like these because a single mistake in the faulty installation not only leads to water leakage but also cause a complete roof replacement.

So this is it! We recommend you to tie these free knowledgeable hints to your fingertips for fail-proof roof construction. Good luck!